EncodeInMotion.gif 1 MB

Simple Encoding Software

GlueLogix provides the simplest possible encoding software for USB connected FEIG HF readers with purchase of FEIG CPR30 and CPR40 USB model readers.

The general flow is:
  • Look for a new chip
  • Encode the new chip from the hex edit windows
  • Repeat
The software detects the chip type, and uses the right Select and/or Addressed commands for the detected chip.

Because the first 3 blocks of the Ultralight/NTAG chip is read-only, the Ultralight Start Block control lets you select where to start encoding with those chips.

SimpleEncode is built in .Net 4.5 and FEIG development kits. Source code and devkits are available under NDA with FEIG purchase from GlueLogix.